epc635 – 3D TOF Imager 160 x 60 Pixel The epc635 is a fully integrated 3D-TOF imager with a resolution of 160 x 60 pixels (Half-QQVGA). As a system on chip, the epc635 contains next to the CCD pixel-field the complete control logic to operate the device. The output of the chip is 12 bit DCS distance data per pixel,Read more

epc611 - TOF range-finder / 8x8 pixel TOF imager The epc611 chip is a general-purpose, monolithic, fully integrated photoelectric CMOS device for optical distance measurements and object detection. Its working principle is based on 3D TOF measurement. The system-on-chip (SOC) contains: A full data acquisition path including the modulation driver for LEDs or laser diodes, the photo-receiver with an 8x8Read more

The TOFcam-635 is a new design of a miniaturized and cost optimized 3D camera. It is based on the ESPROS Photonics proprietary time-of-flight technology. The depth camera can take and process more than 10 HDR depth images per second in full resolution. The depth images are compensated against ambient light, temperature and reflectivity of the scene. Thanks to the highRead more

The TOFrange-611 is a industrial range finder based on the the time-of-flight principle. It measures the distance to an object by the time it takes for a pulse of light to travel to an object and back to the sensor. In order to do this, the sensor is equipped with a LED light source, high frequency electronics and a veryRead more

epc901 Evaluation Kit The Evaluation Kit epc901 is a fully assembled and tested system for the evaluation of the the epc901 line imager. The Evaluation Kit consists of an epc901 camera module, a mainboard, cables and software. The “Evaluation” main section is equipped with a STM32 ARM Cortex micro controller. This section provides a powerful and flexible development environment forRead more

epc660 Evaluation Kit The epc660 Evaluation Kit is a fully assembled and tested camera system designed for the evaluation of the epc660 Time of Flight (TOF) imager. The foundation of this kit is the DME 660 distance measurement camera which provides all necessary hardware to operate the epc660 imager chip, including both the camera lens and illumination. The system isRead more

Light barriers ranging from millimeters to tens of metersSmoke detectorsLiquid detectors epc111/112 – Fully integrated standalone Light-barrier Driver & Receiver epc110 – Fully integrated configurable Light-barrier Driver & Receiver epc120 – Fully integrated Light-barrier Driver & Receiver with 2-Wire Bus Interface The epc 111 / epc112 is a general purpose, fully integrated self-contained CMOS circuit family to be used inRead more

Light barriers ranging from millimeters to tens of metersLight curtainsSmoke detectorsLiquid detectors epc100 / epc101 – Light-Curtain Device with 2-Wire Bus Interface The epc100 / epc101 chip set is a general purpose CMOS integrated circuit for light-curtain applications. The epc100 is used on the receiver side (Rx) whereas epc101 is on the emitter side (Tx). Up to 1'023 devices mayRead more

IR sensorLight barrierIR camera epc-bp860 – Optical IR bandpass filter 860nm General purpose optical IR bandpass filter at centre wavelength of 860nm. It is deposited on thin glass carrier. The filter is designed as a single peak window filter for the wavelength range of 300 – 1050nm. It is well adapted for applications with high power LED of 850nm (e.g.Read more

PLCSensorsControllers epc700 / epc702 Output-driver, low Side Switch epc701 / epc703 Output-driver, high Side Switch The epc70x family products are general purpose CMOS power switches for 24V interfaces. The devices are capable to drive a load of 50mA at 30VDC. If higher driving current is necessary or the output voltage shall be higher than 30VDC, the chips can be usedRead more